POWER SMITH PWLS100H Manuel D'utilisation page 3

IMPORTANT SAFETY INSTRUCTIONS
•
Ground Fault Circuit Interrupter (GFCI) protection
should be provided on the circuit(s) or outlet(s) to be
used for this light in wet locations. Receptacles are
available having the built-in GFCI protection and are able
to be used for this measure of safety.
•
Use only with an extension cord for outdoor use,
such as an extension cord of cord type: SW, SW-A, SOW,
SOW-A, STW, STW-A, STOW, STOW-A, SJW, SJW-A,
SJOW, SJOW-A, SJTW, SJTW-A, or SJTOW, SJTOW-A.
•
Do not look directly at the lighted lamps to avoid eye
injuries.
•
Always keep the work light away from any
flammable surface or materials.
•
Always check damaged or worn-out parts before
using the work light. Broken parts will affect the work
light operation. Replace or repair damaged or worn
parts immediately. If repairs are needed, consult a
professional electrician.
•
Do not use a pressure washer to clean this product.
•
Do not modify the work light in any way. Unauthorized
modification may impair the function and/or safety and
could affect the life of the product. There are specific
applications for which the work light was designed.
•
Store work light in a secure place out of the reach of
children. Inspect it for good working condition prior to
storage and before re-use.
ASSEMBLY INSTRUCTIONS
attacHInG WoRk LIGHt HeaD to
stanD
1.
Place the stand (9) on a flat surface.
2.
Position the U-Shaped bracket (3) of the work light head
against the stand (9) as shown in FIG 1.
3.
Use the locking knob (6), flat washer and spring washer
to secure the work light head on the stand.
OPERATION
aDJUstInG tHe LIGHt DIRectIon
Your work light can be tilted vertically up to 30° down or
90° up.
To Adjust the Light Direction, loosen the side locking
knobs (5). Adjust the work light head to desired position,
and retighten knobs.
sWItcH actIon
Your work light is equipped with an On/Off switch (7) located
on the back side of the work light. Press the switch once to
turn the work light on and press the switch a second time to
turn it off. Always turn the work light off before unplugging.
English
WaRnInG:
is unplugged and completely cool before attempting to
clean it.
Your work light requires very little care and maintenance.
Simply clean the lens regularly with a non-abrasive cleaner.
This product is warranted free from defects in material and
workmanship for 5 (Five) years after date of purchase. This
limited warranty does not cover normal wear and tear or
damage from neglect or accident. The original purchaser is
covered by this warranty and it is not transferable. Prior to
returning your product to store location of purchase, please
call the Toll-Free Help Line for possible solutions.
For questions about this or any other PowerSmith
product,
Please call Toll-Free:
Or visit our website:
www.
powersmithproducts.com
3
MAINTENANCE
Always make sure the work light
WARRANTY
HELP LINE
888-552-8665.
®