Dell PowerConnect 6200 Série Guide D'utilisation page 306

Would you like to run the set up wizard (you must answer this question within 60 seconds)? [Y/N] y
Step 1:
The system is not set up for SNMP management by default. To manage the switch using SNMP (required for Dell Network Manager) you can:
o Set up the initial SNMP version 2 account now.
o Return later and set up other SNMP accounts. (For more information on setting up an SNMP version 1 or 3 account, see the user documentation).
Would you like to set up the SNMP management interface now? [Y/N] y
To set up the SNMP management account you must specify the management system IP address and the "community string" or password that the
particular management system uses to access the switch. The wizard automatically assigns the highest access level [Privilege Level 15] to this
account. You can use Dell Network Manager or other management interfaces to change this setting and to add additional management system later.
For more information on adding management systems, see the user documentation.
To add a management station:
Please enter the SNMP community string to be used {public}:
>> Dell_Network_Manager<Entrée>
Please enter the IP address of the Management System (A.B.C.D) or wildcard (0.0.0.0) to manage from any Management Station {0.0.0.0}:
>> 192.168.1.10<Entrée>
Step 2:
Now we need to set up your initial privilege (Level 15) user account. This account is used to login to the CLI and Web interface. You may set
up other accounts and change privilege levels later. For more information on setting up user accounts and changing privilege levels, see the
user documentation.
To set up a user account:
Please enter the user name {admin}: admin<Entrée>
Please enter the user password: ********<Entrée>
Please reenter the user password: ********<Entrée>
REMARQUE : Si les mots de passe entrés dans les deux champs ne sont pas identiques, un message invite l'utilisateur à recommencer.
Step 3:
Next, an IP address is set up. The IP address is defined on the default VLAN (VLAN #1), of which all ports are members. This is the IP address
you use to access the CLI, Web interface, or SNMP interface for the switch. Optionally you may request that the system automatically retrieve
an IP address from the network via DHCP (this require that you have a DHCP server running on the network).
To set up an IP address:
Please enter the IP address of the device (A.B.C.D)or enter "DHCP" (without the quotes) to automatically request an IP address from the network
DHCP server (192.168.2.1):
>> 192.168.2.1<Entrée>
Please enter the IP subnet mask (A.B.C.D or /nn){255.255.255.0}:
>> 255.255.255.0<Entrée>
REMARQUE : Si vous avez sélectionné DHCP ci-dessus, le système ne vous demande pas de masque de sous-réseau IP car cette information est fournie
par le serveur DHCP.
Step 4:
Finally, set up the default gateway. Please enter the IP address of the gateway from which this network is reachable (for example 0.0.0.0): >>
192.168.2.100<Entrée>
REMARQUE : Si vous avez sélectionné DHCP ci-dessus, le système ne vous demande pas de passerelle par défaut car cette information est fournie par
le serveur DHCP.
This is the configuration information that has been collected:
SNMP Interface = "Dell_Network_Manager"@192.168.1.10
User Account set up = admin
Password = **********
Management IP address = 192.168.2.1 255.255.255.0
Default Gateway = 192.168.2.100