bloom fresco Instructions page 18

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
To disengage
Pull the metal lever outwards fully. Check the
device is disengaged by turning the seat unit.
a
Swivel and Height Adjustment
To rotate the seat unit, disengage the swivel/
height resistor, then turn the seat unit sideways
to desired position.
To adjust seat height, disengage the
swivel/height resistor. Lift both A & B trigger
simultaneously, whilst pushing downwards or
pulling upwards to desired height, then release
the triggers.
IMPORTANT!
Ensure the seat unit is firmly inserted onto the
swivel shaft before use. Check the seat unit
is assembled properly by trying the height
adjustment function, following the instructions
in this user guide. If the height adjustment fails
to work, this means the seat unit is not properly
assembled, please re-try and press seat unit
downwards on the swivel shaft firmly in order
to properly engage the height adjustment
mechanisms.
a4
Lift & Glide – Easy Glide Wheels
To move the baby chair across floor, first rotate
the seat unit so it is front facing, then engage
swivel resistor. Tilt the baby chair forward by
lifting on the handle located on the rear of the
seat unit, and then glide the highchair across
floor using the castor wheels, which are located
under the front end of the base.
WARNING:
• Continue to assemble the baby chair
according to the configuration suitable for your
child. Follow the corresponding instructions
carefully.
• A child's safety is your responsibility.
Section B: Cradle Mode
– suitable for 0 – 6 months (refer to
illustrations section b)
WARNINGS:
• Not recommended for children who can sit
up by themselves (6 months approximately).
• Never leave the child unattended when the
baby chair is in cradle mode.
• It is dangerous to put this cradle on an
elevated or uneven surface.
• Keep the product away from open fire,
heaters and other sources of strong heat.
• Do not use the product unless all
components are correctly fitted and
adjusted.
b
-
b
Seat pad & Safety Harness Assembly
– (parts #05, #06) Put shoulder straps through
the seat pad slits at the lower height setting.
– Put waist straps through the seat pad slits.
– Place seat pad onto the seat unit; secure onto
velcro.
– (part #10) Behind the seat pad, slide the
buckle on the end of the shoulder straps into
the buckle slots located on the inner face of
seat unit. Check the straps are secured by
pulling on the straps.
eng


Publicité

Table des Matières
loading

Produits Connexes pour bloom fresco

Table des Matières