Auto Mode; Audio Triggering; Blackout; Tap Sync - Chauvet DJ Foot-C2 Manuel D'utilisation

Auto Mode

Audio
Triggering

Blackout

Tap Sync

Manual
Override
Page 20 of 88
Auto mode sets the steps in chases to trigger automatically, based on the set speed and
fade times.
To enable Auto mode, do the following:
1. Play back a chase.
2. Press <UP (AUTO)> until the display on the right shows AUTO.
Audio mode sets the steps in chases to respond to audio triggers, from either the internal
microphone, or an external audio source through the Audio Line Input jack on the rear
panel.
To enable Audio Triggering, follow the instructions below:
1. Play back a chase.
2. Press and hold <DOWN (MUSIC)> until the display on the right shows MUSIC.
3. Turn the AUDIO SENS knob up until the scenes or steps are triggered by sound as
desired.
Blackout mode sets all DMX outputs to zero while active. There are two ways to activate
or deactivate Blackout mode:
·
Press <BLACKOUT>
or
·
Press and hold <BLACKOUT / FUNCTION> for three seconds.
Either method can deactivate Blackout, regardless of how it was activated.
While Blackout mode is active, the indicator LED next to <BLACKOUT> will light
up.
The Tap Sync feature allows the user to set the auto and fade speeds with their foot. To
activate Tap Sync:
1. Play back a chase in Auto mode.
2. Press and hold <MODE> for three seconds. The display on the right will show
TAPSY.
3. Release <MODE>.
4. Press <ENTER (TAPSYNC)> at the desired tempo. Do this several times to ensure
the tempo is set. (The time between the first and second press is the speed, the time
between the second and third press is the Fade)
To deactivate Tap Sync, press and hold <MODE>.
During playback, the Color knobs can take priority over the scene or chase playing back.
To manually override a recorded program, do the following:
1. Play back a scene or chase in any mode.
2. Use buttons <1>–<6> to select the fixture(s) to be overridden.
3. Use the Color/Number knobs to alter the output of the selected fixture(s).
Once a Color knob has been moved, the knob will completely supersede the program for
the selected fixture(s). For example: If all fixtures are set to output blue for a scene, fixture
1 is selected, and the BLUE knob is turned all the way down, then fixture 1 will not output
blue.
To turn off Manual Override, use buttons <1>–<6> to deselect any selected fixtures.
Foot-C 2 User Manual Rev. 1