LG DLEX7600 E Serie Manuel Du Propriétaire page 14

14 INSTALLATION
6
With the hinges and cover caps in the new
locations, remount the inner door frame onto the
outer door frame with the screws removed in
step 4 above.
WARNING
Be sure to support the weight of the door before
installing the hinge screws.
7
Reinstall the door.
While supporting the door, install the four hinge
screws removed in step 2. Test the swing of
the door to make sure the hinges and latch are
properly aligned and that the door opens, closes
and latches properly in both directions.
Swing
Door
Easy load door (on some models)
WARNING
Be sure to support the weight of the door before
installing the hinge screws.
ON THE CABINET :
1
Open the door from the side so that the hinge
screws are accessible.
2
Remove the four hinge screws
While supporting the door, remove the four hinge
screws, two from each hinge. Set the door aside
face down on a protected surface to prevent
damage to the door or the work surface.
3
Reverse the components on the cabinet.
mechanism
a. Use a Phillips screwdriver to remove the two
b. Remove the latch hole cover by gently prying it
c. Remove the hinge cover by gently prying it up
d. Reverse the hinge and the hinge bracket at
Two large
screws
Two small
screws
Hinge
cover
latch
Hinge
screws and the latch mechanism on the front
panel of the cabinet.
up with a flat blade screwdriver, being careful
not to scratch the paint. Install the latch hole
cover on the opposite side, where the latch
mechanism was removed. Install the latch
mechanism in the position from which you
removed the latch hole cover, using the two
screws removed in step a.
with a flat blade screwdriver, being careful not
to scratch the paint. Rotate the hinge cover
180 degrees and install it on the opposite side,
where the upper hinge was attached.
the bottom of the cabinet. Remove the two
screws from the hinge bracket at the bottom
right and remove the hinge bracket. Remove
the lower of the two screws behind the hinge
bracket. Do NOT remove the upper screw
behind the hinge bracket. Set the parts aside.
Upper
hinge
Latch
hole
cover
Hinge
bracket