Attaching The Hose - Power Fist U252SVPA Manuel De L'opérateur

Pre-Operation (continued)

ATTACHING THE HOSE

WARNING: Do not attempt to modify this product or
create accessories not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
WARNING: Do not attach the air chuck or other tools
to the open end of the hose until start-up has been
completed.
WARNING: Do not allow familiarity with products to
make you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING: Always wear safety goggles or safety
glasses with side shields when operating power tools.
Failure to do so could result in objects being thrown
into your eyes resulting in possible serious injury.
The compressor is assembled at the factory and
ready for use. Check all components to ensure secure
assembly, (such as rubber feet, handle, quick connects,
gages, safety valve, air filter, drain valve, etc.)
□
Make sure the power to the air compressor is
disconnected.
□
Apply thread tape to the threaded connections of
the hose, and attach the quick connect to the hose
using a wrench (not included).
□
Rotate the pressure regulator knob (1) fully
counterclockwise.
□
Insert the hose adapter end of the air hose (2) into
the female coupler end in the air compressor (3).
1
2
11 - ENG
For technical questions call 1-800-665-8685
3