Installation; Preparation; Points To Be Considered When Re-Transporting Your Refrigerator; Before Operating Your Refrigerator - Beko BU 1200 HCA Mode D'emploi

Masquer les pouces Voir aussi pour BU 1200 HCA:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 48
3

Installation

C
Please remember that the
manufacturer shall not be held liable if
the information given in the instruction
manual is not observed.

Preparation

Your refrigerator should be installed at
least 30 cm away from heat sources
such as hobs, ovens, central heater
and stoves and at least 5 cm away
from electrical ovens and should not be
located under direct sunlight.
The ambient temperature of
the room where you install your
refrigerator should at least be 10°C.
Operating your refrigerator under
cooler conditions than this is not
recommended with regard to its
efficiency.
Please make sure that the interior of
your refrigerator is cleaned thoroughly.
If two refrigerators are to be installed
side by side, there should be at least 2
cm distance between them.
Original packaging and foam
materials should be kept for future
transportations or moving.
Points to be considered
when re-transporting your
refrigerator
1. Your refrigerator must be emptied and
cleaned prior to any transportation.
2. Shelves, accessories, crisper and etc.
in your refrigerator must be fastened
securely by adhesive tape against any
jolt before repackaging.
3. Packaging must be tied with thick
tapes and strong ropes and the rules of
transportation printed on the package
must be followed.
Please remember...
Every recycled material is an indispensable
source for the nature and for our national
resources.
If you wish to contribute to recycling the
packaging materials, you can get further
information from the environmental bodies
or local authorities.
Before operating your
refrigerator
Before starting to use your refrigerator
check the following:
1- Is the interior of the refrigerator dry and
can the air circulate freely in the rear of
it?
2- Clean the interior of the refrigerator as
recommended in the "Maintenance
and cleaning" section.
3- Plug the refrigerator into the wall outlet.
When the door is open the respective
interior light will come on.
4- You will hear a noise as the
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal. Due to the
operation of fans inside the appliance,
overall noise level is slightly higher
in comparison to non-frost free
appliances. This is quite normal and is
not a fault.
5- Front edges of the refrigerator may
feel warm. This is normal. These areas
are designed to be warm to avoid
condensation.
7
EN

Publicité

Table des Matières
loading

Table des Matières