Features; Specifications - 3M Macurco Directives D'utilisation

Features

• Listed to UL standard 2075 for the Standard For Safety for Gas and Vapor Detector and Sensors.
• Tested to UL 2075 using UL 2034 Sensitivity limits for carbon monoxide gas.
• Surface mounts to a wall using the supplied enclosure rear housing.
• Flush mounts in a 2 x 4 inch (1-1/2 inch deep minimum) [5.08 cm x 10.16 cm (3.81 cm deep minimum)] single gang
switch, or handy electrical box.
• Small, low profile, attractive unit in a white plastic case.
• Detector alarms at multiple levels of exposure to carbon monoxide based on time weighted averages of the gas present.
• Inexpensive, easy to install. Microcomputer control allows mostly automatic operation.
• Test & Reset switch conducts internal tests and actuates alarm relay.
• Visual display: GREEN - Normal operation.
• FLASHING AMBER - Trouble Contact your installer or 3M Technical Support
• RED - Danger! Move to fresh air (hazardous condition is present.)
• Highly linear electrochemical sensor
• N.O. or N.C. SPST Alarm Relay and N.C. SPST Trouble relay to connect to Alarm Control Panels
• Buzzer: Produces repeating loud tone bursts during alarm, and chirps if sensor trouble is found.

Specifications

• Voltage: 9-32 VDC
• Current (normal / alarm): 15mA / 35mA @ 9-32V
8