Purpose Of Use; Work Area Safety - Beta 7041LCD/4S Notice D'utilisation Et Instructions

OPERATION MANUAL AND INSTRUCTIONS
OPERATING MANUAL AND INSTRUCTIONS FOR WELDING MASK MANUFACTURED BY: :
BETA UTENSILI S.P.A.
Via A. Volta 18,
Original documentation drawn up in ITALIAN.
CAUTION
IIMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING THE
LAMP. FAILURE TO COMPLY WITH THE SAFETY STANDARDS AND
OPERATING PROCEDURES MAY RESULT IN SERIOUS INJURY.
Store the safety instructions with care and hand them over to the users.

PURPOSE OF USE

- The welding mask can be used for the following purposes:
• Manual arc welding, gas shielded arc welding
• Plasma arc cutting
• Grinding
- The welding mask must not be used for the following purposes:
• Use for laser welding or oxygen acetylene welding.
•
• Use in damp or wet environments or environments exposed to the weather
• Use for any applications other than the stated ones

WORK AREA SAFETY

because sparks may be generated, which can ignite the dust or fumes.
Keep children and bystanders away from your workplace while using the welding mask. Distraction from other people can
cause you to lose control over the welding mask during use.
Do not inhale any gases or fumes while carrying out welding jobs.
WELDING MASK SAFETY
- Before use, check that the welding mask has not been damaged.
screen guards.
by dust.
- Check that no operating parts are worn off or damaged. Any scratched or broken parts should be replaced immediately, so as
not to incur any personal injury.
- Choose the right shade number according to machine type and welding current.
not use any corrosive solvents or detergent dilution petrol.
PERSONNEL SAFETY INSTRUCTIONS
medication.
- Carry out all operations in well-aired, dry rooms.
- Do not wear loose clothing, jewellery or metal objects when carrying out welding jobs.
- Replace the welding mask in a dry area, making sure not to damage it.
The welding mask alone does not protect you from all possible hazards arising from welding jobs. Additional
personal protective equipment may be required, depending on the values found in the environmental hygiene/risk
analysis, if the values exceed the limits under current regulations.
EN
7