Publicité
Les langues disponibles
Les langues disponibles
Ultra
™
Fountain and Statuary Pump
Installation & Maintenance Instructions
Congratulations on your purchase of this Ultra
You will find this pump ideal for use in water gardens, ponds and to
power small ornamental fountains and statuaries. These pumps are
very energy efficient, using 50% less power than conventional pumps.
They are designed to be operated fully submerged and can be
operated in line. Made with environmentally friendly materials,
they are fish safe. The pumps are fitted with a pre-filter system to
prevent clogging and wear on the impeller. The motors are epoxy
encapsulated, not oil filled.
1) Features
• Fully submersible and energy efficient
• Powers ornamental fountains and statuary
• Prefilter system built in prevents clogging
• Fish safe, environmentally friendly materials
• KEEP THIS MANUAL–DO NOT THROW AWAY!
2) Installation
2.1 If a fountain is not required, connect hose directly to the outlet adapter and secure with
hose clamp.
2.2 Place pump in pond. If fountain is in use, ensure fountain head is above water level.
2.3 Plug pump cord into grounded outlet. Ensure cable is protected — keep away from
children and garden hazards. For proper operation, ensure that inlet is filled with water.
2
Pump
submersible pump.
™
Scala/Scale
1:2
Legenda/Legend:
-Tav. 1, ULTRA 2000;
-Tav. 2, ULTRA 1500
-Tav. 3, ULTRA 1000
-Tav. 4, ULTRA 750
-Tav. 5, ULTRA 500
-Tav. 6, ULTRA 350
3) Maintenance
3.1 Remove pump from electrical supply.
3.2 Wash cage in fresh, running water. Never use chemical detergents when cleaning. Handle
filter sponge material carefully.
3.3 Remove impeller, inspect and clean in running water; replace if worn or damaged.
3.4 Reassemble pump; reconnect to electrical supply.
Maintenance notes:
• Check cord periodically for sharp bends and correct.
• If pump is taken out of service, flush with fresh water and allow to drain dry prior to storage.
4) Pump Performance
Model
gph full open
350 gph
368
500 gph
525
750 gph
788
1000 gph
1050
1500 gph
1575
2000 gph
2100
CAGE
Scala/Scale
1:2
CAGE NOSE
Legenda/Legend:
-Tav. 1, ULTRA 2000;
-Tav. 2, ULTRA 1500
-Tav. 3, ULTRA 1000
-Tav. 4, ULTRA 750
-Tav. 5, ULTRA 500
-Tav. 6, ULTRA 350
VOLUTE
O-RING
IMPELLER
cord Length
gph @ 2'
gph @ 5'
Max Head
12'
315
158
7'
12'
420
263
8'
25'
704
525
12'
25'
945
777
15'
25'
1355
998
22'
25'
1880
1523
25'
CAGE
Figure 1
Pump 2000 GPH
CAGE NOSE
REAR BEARING
BASE
O-RING
REAR BEARING
IMPELLER
thread size
Watts
1/2"
35
1/2"
40
3/4"
45
3/4"
50
3/4"
90
3/4"
150
243
9,569
BASE
3
Publicité
