How To Use; Before Use - LG SIGNATURE URNTS3106N Manuel Du Propriétaire

22

HOW TO USE

HOW TO USE

Before use

Clean the refrigerator.
Clean the refrigerator thoroughly and wipe off all dust that accumulated during
shipping.
• Do not scratch the refrigerator with a sharp object or use a detergent that
• Do not peel off the model or serial number label or the technical information
NOTE
Open refrigerator and freezer doors to ventilate the interior.
The inside of the refrigerator may smell like plastic at first. Remove any adhesive
tape from inside the refrigerator and open the refrigerator and the freezer doors for
ventilation.
Connect the power supply.
Check if the power supply is connected before use.
Read the "Turning On The Power" section.
Turn off the icemaker if the refrigerator is not yet connected to the
water supply.
Turn off the automatic icemaker and then plug the power plug of the refrigerator
into the grounded electrical outlet.
* This is applicable only to certain models.
Wait for the refrigerator to cool.
Allow your refrigerator to run for at least two to three hours before putting food in
it. Check the flow of cold air in the freezer compartment to ensure proper cooling.
The refrigerator makes a loud noise after initial operation.
This is normal. The volume will decrease as the temperature lowers.
CAUTION
contains alcohol, a flammable liquid or an abrasive when removing any tape
or adhesive from the refrigerator,.
on the rear surface of the refrigerator.
Remove adhesive residue by wiping it off with your thumb or dish detergent.
CAUTION
Running the automatic icemaker before connecting it to the water
supply may cause the refrigerator to malfunction.
CAUTION
Putting food in the refrigerator before it has cooled could cause the
food to spoil, or a bad odor could linger inside the refrigerator.