PROUSER DRC4310DC Mode D'emploi page 13

Système de camerade recul sans fil numerique & dashcam avec écran 10,9cm
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6. RESET (small button on the backside of the unit)
If the system has frozen or you want to reset the unit to factory settings, press the RESET-button with
a clip or a toothpick.
Taking Photos and Videos
-
If the device is in standby, press the UP or DOWN-button to switch between Video-mode and
Photo-mode.
-
In Video-mode, press the UP -button to record a video
-
In Photo-mode, press the DOWN-button to take a photo.
System Menu and System Settings
-
Press the Menu-button to enter the menu screen.
-
Select the settings-menu you want to edit with the UP/DOWN buttons p q and confirm your
selection with the ENTER-button. Press the BACK-button to return to the previous page or quit.
Video-Settings
Resolution: The higher the resolution, the better is the picture quality but also memory usage.
Possible selections are:
- VGA 640 x 480
- WVGA 848 x 480
- HD 720p 1280 x 720
Loop Recording: Off / On
If Loop-Recording is turned on, the last video-file will be overwritten with the current.
Record time:
In this setting, you can define, how long a video file shall be recorded.
Possible selections are: 1 Minute / 2 Minutes / 3 Minutes / 5 Minutes / 10 Minutes
G-Sensor:
Possible selections are: Off / 2G / 4G / 8G
If activated, the device can notice an impact or a crash and automatically lock the current video
file and store it. This mechanism prevents the file from being overwritten.
Since the sensor might be even triggered on bumpy roads, it´s sensitivity can be adjusted to
improve the detection accuracy and to avoid false positives (and increased memory usage).
A current recording can also be locked manually by pressing the BACK-button.
Note: Since locked files may need a large amount of storage capacity, it is recommended to check
regularly if not-needed files can be deleted.
G-Sensor record
Possible selections are: Off / 2G / 4G / 8G
If activated, the device will automatically start a video recording and also protect this file from
being overwritten when the g-sensor is triggered in standby-mode (e.g. when your vehicle is
parked and got hit). Sensibility can also be adjusted.
Microphone: Off / On
Turn audio in video recordings on or off.
Power on record: Off / On
Automatically start a recording when the device is powered on.
13

Publicité

Table des Matières
loading

Table des Matières