oneConcept Streamo Cube Mode D'emploi page 44

EN
The number of bars in the wireless symbol in front the network name(SSID)
shows the relative signal strength of the network. The key symbol indicates
that the network is password-protected.
If the device does bot find any wireless networks, , No wireless Networks
found' appears on the display. Change your location, if necessary. And
check your WLAN router. You can find the SSID of your Access Point in the
configuration of the Access Point(Router). Select your network and confirm
witk OK. If your WLAN is password-protected, you will be prompted to enter
your password.
Enter the password using the buttons on the device or the number and
letter of the remote control. Note the use of upper and lower case when
entering the password.
You can rotate reel to choose the code. If it is accidentally pressed '' to
move a redundant entry. Press '' to correct.
With remote control
The cursor indicates the current entry space.
Press the corresponding number button repeatedly.
0 0(delete entry)
1 1(space) @ ! " # $ % & ( ) * ' + - { \ | }< >?........
2 2 A B C a b c
3 3 D E F d e f
4 4 G H I g h i
5 5 J K L j k l
6 6 M N O m n o
7 7 P Q R S p q r s
8 8 T U V t u v
9 9 W X Y Z w x y z
buttons:
: Go to previous entry space, entry can be overwritten
: Go to next entry space, the last entry is saved
  elect number/letter
Enter Confirm entire entry.
It may take a few seconds to
establish the connection to the
network
44