LED INDICATORS / TÉMOINS DEL
FRONT RED LED (INTRUSION) / DEL ROUGE AVANT (INTRUSION)
Warm Up / Démarrage
Sensor Location Feature / Fonction de
localisation de capteur
Enter/Exit walk test mode / Entrer/quitter
le mode Test par déplacement
Trouble / Anomalie
Movement Detected with no Pet Immunity
/ Panel programmable / Mouvement
détecté sans insensibilité aux
animaux/programmable depuis le
panneau
Movement Detected with Pet Immunity /
Panel programmable / Mouvement
détecté avec insensibilité aux
animaux/programmable depuis le
panneau
FRONT GREEN LED (OCCUPANCY) / DEL VERTE AVANT (PRÉSENCE)
Off / Arrêt
Occupant Detection / Détection d'un
occupant
REAR GREEN LED (ENROLLMENT) / DEL VERTE ARRIÈRE (ENREGISTREMENT)
Enrolled in a network / Enregistrée dans
un réseau
Enrollment Confirmation / Confirmation
d'enregistrement
Enrolled and programmed into the
controller's network / Enregistré et
programmé sur le réseau du contrôleur
Delete / Supprimer
Tamper (already enrolled) / Sabotage
(déjà enregistré)
DETECTION PATTERNS / CHAMPS DE DÉTECTION
SPECIFICATIONS/SPÈCIFICATIONS
Battery / Pile ............................................................................................... Two 3-volt lithium; Duracell DL123A, Panasonic CR123A, or HUIDERUI CR123A. / Deux 3 volts' au lithium; Honeywell 466
Full Range / Plein Portée ............................................................................ Security / Sécurité: 30ft x 42ft (9m x 12.8m) / Occupancy / Présence : 23ft x 32ft (7m x 9.8m)
Angle of Detection/ Angle de détection ....................................................... 90 Degrees/ Degrés
Default Sensitivity Setting/ Paramètre de sensibilité par défaut .................. Lowest Sensitivity, Pet Immunity Enabled / Sensibilité la plus basse, immunité aux animaux activée
Wall Mounting Height / Hauteur de montage au mur : ................................. 7' – 9' (2.1 m – 2.7 m); Optimal 7'6" (2.3 m).
RF Frequency / Fréquence RF.................................................................... 2.4 GHz
Tamper / Interrupteurs antisabotage: .......................................................... Cover/ Couvercle
Dimensions / Dimensions ........................................................................... 4.5 in. diameter / 11.4 cm diamétre, 2.5" deep / 6.3 cm profound
Relative Humidity / Humidité de fonctionnement ......................................... 95% (Agency Compliance – 93%), Non-condensing / 95% max. (Agence de conformité - 93% max.) sans Condensation
Operating Temperature / Température de fonctionnement : ....................... 32° – 122°F / 0° – 50°C
Weight / Poids: .......................................................................................... 4.34 oz / 123.04g (poids net)
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE CONTROL WITH WHICH THIS DEVICE IS USED, FOR DETAILS REGARDING
LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
OUR LES LIMITES DU SYSTÈME D'ALARME AU COMPLET, REPORTEZ-VOUS AU GUIDE D'INSTALLATION DU PANNEAU DE COMMANDE.
FEDERAL COMMUNICATIONS COMMISSION (FCC) & INDUSTRY CANADA (IC) STATEMENTS
The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or
User's Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment.
CLASS B DIGITAL DEVICE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, as defined by FCC Rules Part
15.105. The Class B Digital Device statement can be viewed at:
https://customer.resideo.com/en-US/support/residential/codes-and-standards/FCC15105/Pages/default.aspx
FCC / IC STATEMENT
This device complies with Part 15 of the FCC Rules, and Industry Canada's license-exempt RSSs. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Cet appareil est conforme à la partie 15 des règles de la FCC et exempt de licence RSS d'Industrie Canada. Son
fonctionnement est soumis aux conditions suivantes: (1) Cet appareil ne doit pas causer d'interférences nuisibles. (2) Cet
appareil doit accepter toute interférence reçue y compris les interférences causant une réception indésirable.
Responsible Party / Issuer of Supplier's Declaration of
Conformity: Ademco Inc., a subsidiary of Resideo
Technologies, Inc., 2 Corporate Center Drive., Melville, NY
11747, Ph: 516-577-2000
SUPPORT AND WARRANTY / SOUTIEN ET GARANTIE
For online support information, please go to: https://mywebtech.honeywellhome.com/
Pour de l'assistance en ligne, visitez : https://mywebtech.honeywellhome.com/
For the latest warranty information, go to: https://www.security.honeywellhome.com/hsc/resources/wa/index.html
Pour les dernières informations de garantie, s'il vous plaît aller à : https://www.security.honeywellhome.com/hsc/resources/wa/index.html
For patent information, see https://www.resideo.com/patent
Pour des informations sur les brevets, voir https://www.resideo.com/patent
Ê800-23891ZŠ
800-23891 2/18 Rev A PART 1
TIME DURATION /
PATTERN / MODELE
DUREE
Steady Blink (1s/1s) /
6-45 seconds /
Clignotement continu (1 s/1 s)
secondes
ON when zone selected; OFF
when not selected / Allumée
Time of selection /
lorsque la zone est
Temps de sélection
sélectionnée; éteinte lorsqu'elle
n'est pas sélectionnée
Quick Flash / Clignotement
2 seconds / 2 secondes
rapide
Slow then long blinks /
Flash if the error exists /
Clignotements lents, puis longs
Flash si l'erreur existe
Slow Blink / Clignotement lent
3 seconds / 3 secondes
3s ON / Allumée 3 s
3 seconds / 3 secondes
S.O.
S.O.
3s Slow Blink / Allumée 3 s
3 seconds / 3 secondes
Clignotement lent
0-60 seconds / 0-60
Fast Blink / Clignotement rapide
secondes
3s ON / Allumée 3 s
3 seconds / 3 secondes
3 seconds ON / Allumée 3 s
3 seconds / 3 secondes
Fast Blink / Clignotement rapide
2 seconds / 2 secondes
Short Flash every 3s /
Clignotement court toutes les
10 minutes
3 s
Partie responsable / Émetteur de la déclaration de
conformité du fournisseur : Ademco Inc., une filiale de
Resideo Technologies, Inc., 2 Corporate Center Drive.,
Melville, NY 11747, Tél. 516 577-2000
OCCASION
Power On / Mise sous tension
When the user selects the zone in question in
controller programming / Lorsque l'utilisateur
sélectionne la zone dont il est question dans la
programmation du contrôleur
Enter or Exit Walk Test mode / Entrer ou quitter le
mode Test par déplacement
Self-Test Error / Erreur d'auto-essai
Movement detected in walk test mode / Mouvement
détecté en mode test par déplacement
Movement detected in walk test mode / Mouvement
détecté en mode test par déplacement
Normal operation when no activity detected /
Fonctionnement normal lorsqu'aucune activité n'est
détectée
Movement detected in walk test mode / Mouvement
détecté en mode test par déplacement
Powered on, seeking enrollment to the controller /
Allumée, tente de s'enregistrer dans le contrôleur
Process is complete and enrollment confirmed /
Processus terminé et enregistrement confirmé
Upon power up / Pendant la mise sous tension
During deletion from the panel / Pendant la
suppression depuis le panneau
Tamper triggered, while the tamper is faulted /
Sabotage enclenché, pendant la mise en défaut du
sabotage
PRODUCT MUST BE TESTED AT LEAST ONCE EACH YEAR
LE FONCTIONNEMENT DU PRODUIT DOIT ÊTRE VÉRIFIÉ AU MOINS UNE FOIS PAR ANNÉE
For full details, refer to the installation instructions (document # 800-23973) at
https://mywebtech.honeywellhome.com.
Approval Listings / Approbations Homologations
FCC / IC
cETLus Listed
Conforms to UL 639 / Certified to ULC-S306-03
RF EXPOSURE
Warning – The antenna(s) used for this device must be
installed to provide a separation distance of at least 7.8
inches (20 cm) from all persons and must not be co-located
or operating in conjunction with any other antenna or
transmitter except in accordance with FCC and ISED multi-
transmitter product procedures.
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
2018 Resideo Technologies, Inc.
www.resideo.com
Other Standards:
SIA-PIR-01
RoHS
MISE EN GARDE
Exposition aux Fréquences Radio: La/les antenne(s)
utilisée(s) pour cet émetteur doit/doivent être installée(s) à
une distance de séparation d'au moins 20 cm (7,8 pouces)
de toute personne et ne pas être située(s) ni fonctionner
parallèlement à tout autre transmetteur ou antenne, excepté
en conformité avec les procédures de produit multi
transmetteur FCC et ISED.
MyWebTech
Warranty
The Honeywell Home Trademark is used under license from Honeywell International Inc.
All other trademarks are the properties of their respective owners. All rights reserved.
La Honeywell Home est une marque de commerce de Honeywell International inc. utilisée sous
licence par Resideo Technologies, inc. Toutes les autres marques de commerce appartiennent à
leurs propriétaires respectifs. Tous droits réservés.
Patents