Klarfit Pacemaker X3 Mode D'emploi page 16

Activating the treadmill:
Put the electrical plug in a grounded wall outlet and then turn on the
power switch on the front right side of the treadmill (see picture 1) .
As soon as the power is turned on a short sound is emitted that me-
ans the product is in stand-by mode. Attach the safety strap magnet
(see picture 2) in the round hole on the front of the control panel.
(The display shows "- - -" if you have not attached the safety strap
on the front of the display).
Starting the belt:
Press the start button, The display counts down and beeps three
times. The belt starts at the lowest
speed (0,8km/h], the pre—set program time is 60 minutes.
Changing speed:
There are several ways of changing speed.
• Increase/decrease speed with the arrow buttons on the control
panel.
• Increase speed with the + / - button on the handrail.
• Go straight to 3, 5, 7km/h with the quick choice buttons on the
control panel.
Changing program time before starting in manual control
mode:
• Press the Mode button once (the display shows 30 minutes).
• Select desired program time (total minutes) with the t/s
• Press the start button, the display counts down and beeps three
times. The belt starts at the lowest speed (0,8km/h).
• Select desired speed.
• The display counts down from the selected time.
Choosing distance before start in manual control mode:
• Press the Mode button twice (the display shows 1 km).
• Select distance (total km) with the arrow buttons.
• Press the start button, the display counts down and beeps three
times. The belt starts at the lowest speed (0,8km/h].
• Select desired speed.
• The display counts down from the selected distance
Using the twelve atomatic programs P01-P12
• Press the PROG button until the desired program is shown in the display.
• The pre-set time 30 minutes blinks in the display. Use the arrwo buttons to enter the desired time
(5-60 minutes).
• Press the start button. The automatic program starts after a three second countdown.
Console: Operation
16