Klarfit Pacemaker X3 Mode D'emploi page 14

Adjusting Incline
Loosen the locking screw one turn. Move the pin to desired position (there are three choices]
Top hole (level position), middle hole (3.5% incline), bottom hole (7% incline) Release the pin
by pulling it straight out and secure the pin by pushing it straight in. Tighten the locking screw.
Adjust the treadmills incline with the help of the pin on the adjustable feet
Folding For Storage
Turn off the treadmill, turn off the main power switch and pull out the plug. Loosen the safety screw. Lift
up the base, pull out and secure the pin on the left side of the frame.
Note: Store the safety screw in the container for locking screws. Note : Check that the belt is centered.
If it is not, adjust the belt so that it runs freely (see section on Regular Maintenance).
14