Klarfit Pacemaker X3 Mode D'emploi page 13

Assembly
Place the treadmill in an upright position. Stand
behind the treadmill, use your left hand to pull
out the locking pin on the left side in the midd-
le of the treadmill (which secures the treadmill
when folded), while at the same time holding
the treadmill with the right hand. Use both
hands when you open out the base onto the
floor.
Screw the locking screw into position (found in
the accompanying bag) at the front of the belt,
on the left side just below the base of the hand-
rail, to secure the treadmill.
Mounting the control panel. Align the control
panel with the screw hole, screw in place with
accompanying M6 screw.
Mount the handrail on frame leg and tighten screw with accompanying Allen key. Mount the modular
contact in the outlet on the right frame leg. Fasten the plastic cover over the screws on the handrail.
13