Adjusting The Brightness; Correcting Distorted Sound; Switching The Sound Muting/Attenuation; Switching The Auxiliary Setting - Pioneer AXM-P8000 Mode D'emploi

Section
08 Initial Settings

Adjusting the brightness

You can adjust the display brightness. Initially
this mode is set to 12.
1 Press o to select Brightness.
Press o repeatedly until Brightness ap-
pears in the display.
2 Press m or n to adjust the bright-
ness level.
Each press of m or n increases or de-
creases the brightness level. 0  15 is dis-
played as the level is increased or
decreased.

Correcting distorted sound

You can minimize distortion that may be
caused by the equalizer curve settings.
! Setting an equalizer level high can cause
distortion. If high sound is crippled or dis-
torted, try switching to Low. Normally,
leave the setting at High to ensure quality
sound.
1 Press o to select Digital ATT.
Press o repeatedly until Digital ATT ap-
pears in the display.
2 Press m or n to select Low or High.
Pressing m or n will switch between High
(high) and Low (low) and that status will be
displayed.
Switching the sound
muting/attenuation
Sound from this system is muted, attenuated
or mixed automatically in the following cases:
36
En
! When a call is made or received using a
cellular telephone connected to this unit.
! When the voice guidance is output from a
Pioneer navigation unit connected to this
unit.
1 Press o to select Tel/Navi.
Press o repeatedly until Tel/Navi appears
in the display.
2 Press m or n to switch the tele-
phone muting/attenuation.
Press m or n until the desired setting ap-
pears in the display.
! Tel/Navi :MUTE  Muting
! Tel/Navi :ATT2  Attenuation
(Tel/Navi :ATT2 has a stronger effect than
Tel/Navi :ATT1)
! Tel/Navi :ATT1  Attenuation
Notes
! The sound is turned off, MUTE or ATT is dis-
played and no audio adjustment is possible.
! Operation returns to normal when the phone
connection is ended.

Switching the auxiliary setting

It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press o to select AUX.
Press o repeatedly until AUX appears in
the display.
2 Press r to turn auxiliary setting on.
AUX :ON appears in the display.
# To turn auxiliary setting off, press q.