Basic Operations; Turning The Unit On; Selecting A Source; Adjusting The Volume - Pioneer AXM-P8000 Mode D'emploi

Section
03

Basic Operations

Turning the unit on

% Press SOURCE to turn the unit on.
When you select a source the unit is turned
on.

Selecting a source

% Press SOURCE to select a source.
Press SOURCE repeatedly to switch between
the following sources:
Digital source 1Digital source 2Televi-
sionDVD player/multi-DVD player
Multi-CD playerExternal unit 1Exter-
nal unit 2AUXAnalog source 1Ana-
log source 2Analog source 3Analog
source 4Analog source 5Analog
source 6
Notes
! DVD source (DVD player/multi-DVD
player) and Digital sources (Digital source1
and 2) can exist simultaneously. However,
DVD player which is connected to the multi-
channel processor (DEQ-P8000) via the IP-
BUS and optical cable should be connected
to OPT IN. 1 connector. Also, equipment
which is connected to the multi-channel pro-
cessor only via the optical cable should be
connected to OPT IN. 2 connector. If not, this
may not operate properly.
! When no source is connected, short beep will
sound when you try to select a source.
! In the following cases, the sound source will
not change:
 When there is no unit corresponding to the
selected source connected to this unit.
 When there is no magazine in the multi-
CD player.
 When there is no magazine in the multi-
DVD player.
 When there is no disc in the DVD player.
12
En
 When the AUX (auxiliary input) is set to off
(refer to page 36).
 When the analog sources are set to off
(refer to page 37).
! External unit refers to a Pioneer product (such
as one available in the future) that, although
incompatible as a source, enables control of
basic functions by this unit. Two external units
can be controlled by this unit. When two exter-
nal units are connected, the allocation of
them to external unit 1 or external unit 2 is
automatically set by this unit.

Adjusting the volume

% Use VOLUME to adjust the sound level.
Press to increase or decrease the volume.

Turning the unit off

% Press SOURCE and hold until the unit
turns off.