Digital Signal Processor; Introduction Of Dsp Adjustments - Pioneer AXM-P8000 Mode D'emploi

Section
07

Digital Signal Processor

Introduction of DSP
adjustments
Important
! You can use the following functions only when
the remote control is set to DEQ mode.
! Following functions are effective only when
you connected a Pioneer multi-channel pro-
cessor (DEQ-P8000) to this unit.
By carrying out the following settings/adjust-
ments in the order shown, you can create a fi-
nely-tuned sound field effortlessly.
1 Setting the speaker setting
2 Using the position selector
3 Auto TA and EQ (auto-time alignment and auto-
equalizing)
4 Adjusting the time alignment
5 Adjusting the speaker output levels using a
test tone
6 Selecting a cross-over frequency
7 Adjusting the speaker output levels
8 Adjusting 3-band parametric equalizer
22
En
Operating the DSP menu
1
1 DSP display
Shows the DSP status.
% Press p to display the DSP function
names.
Press p repeatedly to switch between the
following DSP functions:
Posi (position selector)Fad (balance adjust-
ment)SLA (source level adjustment)DRC
(dynamic range control)DIRECT (direct)
Dolby PLB (Dolby Pro Logic B)Downmix
(down mix)
# To return to the display of each source, press
BAND.
Notes
! If you do not operate the DSP function within
about 30 seconds, the display is automatically
returned to the source display.
! If both the center and the rear speakers are
set to OFF in the DSP details menu (refer to
Setting the speaker setting on page 26), you
cannot use Dolby PLB.