FORGE ADOUR MODERN 60 Mode D'emploi page 8

Raccordement Gaz
Les flexibles de gaz butane/propane sont munis de raccords de différents formats, ils sont signalés de
couleurs différentes.
Pour éviter tous risques de détérioration du raccord de la plancha, veuillez vous reporter à la notice
fournie par le fabricant du flexible.
Raccordement de votre plancha en catégorie I3+ (butane/propane) :
utiliser un détendeur à sécurité NF 28 mbar pour le butane et NF 37 mbar pour le propane.
Le tuyau doit être visible sur toute sa longueur et facilement accessible.
Se conformer aux instructions d'utilisation et de sécurité (ex : date de validité) indiquées par le fabri-
cant du flexible.
La longueur du tube souple ne doit pas dépasser 1.5 mètres.
Chaque brûleur est équipé d'une sécurité par thermocouple, qui provoque la coupure de l'alimentation
en gaz des brûleurs dans le cas d'extinction inopinée de la flamme.
Screw the hose fitting clockwise as shown in the drawing opposite.
The hose must be connected in accordance with the hose manufacturer's instructions, and in compliance
with the standards in force in the country concerned.
Your FORGE ADOUR plancha is configured to work with LPG Butane/Propane liquid Gas depending
on what you requested from your retailer on purchase and purchase and according to local setting
in supply pressure.
The type of Gas to be used is written on the label on the side of your plancha.
The Butane/Propane Gas hoses are equipped with different-sized fittings, and are identified by different
colours. To prevent any risk of damage to the plancha fitting, please refer to the instructions
provided by the hose manufacturer.
Connection of your plancha in the I3+ or I3B/P category (Butane/Propane):
• Use certified pressure regulator complying with standard EN 12864 to be connected to the gas
bottke refer also to national standards specifying pressures to supply the appliances.
• Use a certified flexible hose to connect the plancha; for France refer to standards NFD36-125 for
metallic hoses or XPD36-112 for rubber hose; for the other Countries respect local Rules and Laws.
The entire length of the rubber hose must be visible and easily accessible.
Comply with the safety instructions for use (e.g. use-by date, etc.) specified by the hose manufacturer.
The hose must not be longer than 1.5 meters.
Each burner is fitted with a thermocouple safety device which cuts off the gas supply to the burners if
the flame goes out unexpectedly.
Gas connection
8