Installation Conditions; Installation Procedures; Safety Warning - Maestro Bellini Manuel De L'usager

REQUIREMENTS
Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable,
local and National codes and standards, including fire-rated construction codes and standards.
This range hood must be properly grounded.
Fig.1
Min 21" - Max 24"

INSTALLATION CONDITIONS

1. Do not install the cooker hood where there are many doors or windows this could affect the exhaust
efficiency of the hood caused by air convection.(Fig. 1)
2. Install the cooker hood right above the hob.The recommended distance between the hob and the lower edge
of the cooker hood is minimum 21" and maximum 24". (Fig. 2)
3. In order to get the optimum performance use as few as possible pieces ; long duct runs, elbows, and
transitions for they will reduce the performance. Ducts must all have the same circumference. Seal all joints
and connections with duct tape. (Fig. 3)
4. After hanging the unit on the wall, ensure the hood is perfectly levelled . (Fig. 4)

INSTALLATION PROCEDURES

SAFETY WARNING

This hood may have sharp edges, please wear protective gloves when installing, cleaning or servicing the unit.
This appliance is heavy. A appropriate structure and support must be planned for the installation. The hood must be
secured by anchors and horizontal supports.
anchors
bracket
Fig.2
Step 1:
•
Determine the exact location of the hood
•
Use a level and draw a horizontal line on the wall at the desired
installation height.
•
Then determine the center line of the range/cooktop
6" duct
incl.