Drawings & Product Instruction Visuals; Gas Connections & Regulator(S) - nomadiQ CQ BBQ 001 Manuel D'instructions

27. Although your gas supply cartridge/ cylinder may appear to be empty, gas may still be present, and
the cartridge/ cylinder should be transported and stored accordingly.
28. Make sure you are outdoors and away from any source of ignition when changing or connecting
cartridge or cylinder.
29. After a period of storage and/or non-use, the gas grill should be checked for gas leaks and burner
obstructions before use. See instructions in this instruction manual for correct procedures.
30. A dented or rusty gas supply cartridge/ cylinder may be hazardous and should be checked by your
gas supplier. Do not use a gas supply cartridge/cylinder with a damaged valve.
31. Do not use or store this appliance in areas of high salt content (a marine environment) or an area
with caustic fumes or liquids (such as a domestic pool), as these chemicals can cause the appliance
materials to deteriorate (and void the warranty).
32. Do not carry out any servicing on the gas manifold of the barbecue yourself – this must only be done
by authorised technicians.
33. Do not use charcoal, briquettes or lava rock in this appliance.
34. Do not place grill on glass or a combustible surface.
35. The use of alcohol, prescription drugs, non-prescription drugs, or illegal drugs may impair the consu-
mer's ability to properly and safely assemble, move, store or operate the appliance.
36. This appliance is not intended for and should never be used as a heater.
37. Do not enlarge valve orifice or burner ports when cleaning the valve or burner.
38. Do not build this appliance in any built-in or slide-in construction. Ignoring this warning could cause a
fire or an explosion that can damage property and cause serious bodily injury or death.
2. Drawings & product instruction visuals
Assembly drawing(s) & Part list, reference visuals 1 & 2 on page 3.
1. Belt
2. Belt clips (2x)
3. Grates (2x)
4. Assemble hooks grates (4x)
5. Handles (2x)
6. Grilling shells (2x)
7. Control knobs (2x)
8. Drip-trays (2x)
9. Foot
10. Locking knobs (2x)
Instruction visuals 3 - 27 for operation are shown on, page 4 to 9. Also find the related instructions under
section 'Instructions for use' in the manual.
3. Gas connections & regulator(s)
Connecting a disposable gas cartridge
The product is standard configured for disposable gas cartridges that comply with EN417 standard and have
a screw type connection as shown on visual below. The cartridges should contain butane gasses. These are
common type gas cartridges that can be found at almost every outdoor related retailer worldwide.
Visual EN417 (Lindal valve)
When connecting or changing the gas cartrigde;
- Check if the burners are extinguished and both control knobs are on the 'O' position, before disconnecting
the gas cartrigde, visual A.
- Carefully dismantle the empty cartridge, if applicable, from the gas regulator by screwing it clockwise,
visual A.
- Check if the seal in the gas regulator is in place and good condition,
- Check if the seals of the quick-connectors are in place and good condition,
11. Base
12. Ignitor
13. Locking lips grates (2x)
14. Ignitor spark points (2x)
15. Burners (2x)
16. Quick connectors male (2x)
17. Quick connectors female (2x)
18. Gas hose assembly
19. Gas regulator
visual B
visual C.
12
- Assemble a new cartrigde on the gas regulator by screwing it counterclockwise,
outside and away from people.
- Make sure there's no gas leakage, see 'Leak detection procedure'.
- If everything seems airtight and connected well, you're able to use the appliance again.
Visual A.
Visual C.
Before use ensure that the valve and screw connection is not damaged! Also check if the seals (between
the appliance and the gas container) are in place and in good condition before connecting it to the gas
container.
NomadiQ recommends to use the provided gas hose assembly with disposable gas cartridges as shown
above. When considering to connect alternative gas supplies please contact our Service & After sales for
further advise.
Additional instructions & tips related to the gas supply and connection.
- Disconnect the cartridge if it's empty
- Disconnect the cartridge if the grill is being stored in a garage or other enclosed area
- Disconnect the cartridge if the grill is being transported.
- Avoid kinking the hose.
- Make sure the gas supply is positioned on a stable surface and prevent that the flexible tube is twisted.
- Any parts sealed by the manufacturer must not be altered by the user.
- Any modification of the appliance may be dangerous.
- Gas supplies, especially cartridges may cool down during use and can even show icing on the outside of
the supply. This phenomenon is quite common but might also influence the eventual grilling performance.
Placing the gas supply in a layer of water, keeping the top part of the supply sufficiently above water level,
can prevent this situation.
Leak detection procedure
Make sure the control knobs on the appliance are set on "0" and if applicable, open the valve of the gas
supply/ regulator. Check for leaking joints by brushing with solution of half-liquid detergent and half water.
If a leak is present, bubbles will appear (or you may hear a hissing sound). Retightening connections can ge-
nerally repair a leaking joint. You must also check the gas hose and connection at the gas cylinder. If a leak
cannot be resolved, do not proceed. Contact Service & After sales for further advise.
WWW.NOMADIQBBQ.COM
visual D. Always do this
Visual B.
Visual D.
13