Valore VS-1000C Plus Guide D'installation Et D'utilisation page 7

• Before Installation, insure there is sufficient
clearance to accommodate the shower panel.
A minimum of 23.5" is required between the
shower outlet and top of your existing valve.
Maximum clearance required 42".
Ensure that the water line to the overhead
shower pipe is completely shut off prior to
performing any work.
• Remove the existing shower head and shower pipe.
• Connect the Brass Extender Joint (Part 15) provided
to the shower outlet. Use waterproof plumbing tape
on the pipe threading prior to securing the extender
to prevent leaks.
(Note: The Brass Extender Joint (Part 15) in two
sizes. Choose the appropriate size and ensure the
longer end of threading on the Extender (Part 15)
is facing outward.)
INSTALLATION INSTRUCTIONS
½" diameter is needed to
accommodate the shower panel's
Brass Extender Joint (Part 15)
- 7 -
15
15