Valore VS-1000C Plus Guide D'installation Et D'utilisation page 14

1
• Place the Diverter valve (#5) into the valve body. Note
the one pillar on the bottom of the Diverter valve (#5)
must be aligned with the hole in the rear of the body.
Adjust the knob with right position
3
Shower Head Mode
4
• Once the correct position of the knob has been
determined, place the knob on the valve stem and
tighten the set screw (#1). Do not overtighten.
How to Install the Diverter Valve
5
Diverter valve
2
1
(2.5 mm)
1
2
2
2
• Tighten the gland nut (#4). Take precaution to avoid
scratching the trim plate. Do not force the nut too
tightly.
• Replace the knob (#2) on the valve stem.
• Before securing the knob, turn on the water to know
which way the handle is to be pointed.
5
• Tighten the handle (#3) and finish the install.
- 14 -
4
4
3