Krups Control Line KM442D50 Mode D'emploi page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Place the ground coffee directly inside the permanent filter or the paper filter. The
filter holder has 2 positions - open and closed. Make sure that the filter holder has
been properly locked: the arrow and the lock icon must be facing each other. After
use, throw away the coffee grounds and rinse the filter holder under running water.
The recommended amount of coffee grounds is a level teaspoon (provided) for
standard grounds (do not exceed 10 spoons).
Note : The quantity of coffee brewed will be less than the quantity of water poured into
the coffee machine; approximately 10% of this water will be absorbed by the ground
coffee and filter.
Your coffee maker is equipped with an automatic stop system.
The appliance will stop automatically approximately 30 minutes after the end of the
cycle.
The appliance may also be switched off at any time by pressing the «
Manual mode:
Press the «
that the coffee maker has started up.
To stop the coffee maker, again press the «
there will be two "beeps".
Programming mode Fig. 11 and 12:
Your appliance is equipped with two programming buttons
for example, to set one time during the week and another at the weekend. The two
programming buttons function in the same way.
Press the
within 10 seconds, the timer will go back to the current time.
Enter the time using the "H" (hours) and "MIN" (minutes) buttons. If no other action
is taken, the time entered will be automatically saved after approximately 5 seconds.
The timer will then go back to the current time.
Once programming is complete, the
You can check or change the programming time whenever you like by once again
pressing the
At the programmed time, the coffee maker will turn itself on. Buttons
«
» will light up.
WARNING: The set program is automatically deactivated at the end of the coffee cycle;
however, the set time is saved. Reactivate the set program every day by pressing on the
button
or
appliance in the Program Mode".
Press the «
You can cancel the programming at any time by pressing buttons
than 2 seconds.
Unplug the appliance.
Let the appliance cool down before cleaning it.
To remove the filter holder, make sure that it is in the correct position (Fig. 7).
Throw the coffee grounds into the garbage (Fig. 8a and Fig. 8b).
Clean with a damp cloth or sponge.
4
» button (h), the light will turn on and there will be a "beep" to signal
or
, button and the timer will start to flash. If no setting is selected
or
button.
. In order to set a different time, please refer to paragraph "Using the
» button to stop the cycle.
CLEANING
» button. The light will turn off and
button used will remain lit.
» button (h).
, allowing you,
or
and
or
for more

Publicité

Table des Matières
loading

Table des Matières