Short Cord Instructions - Kalorik WM 42281 Mode D'emploi Et Consignes De Sécurité

Fax +1 305 430 9692
15. Do not use the appliance for other than intended use.
16. When using this appliance, provide adequate airspace above
and on all sides for air circulation. On surfaces where heat may
cause a problem, an insulated hot pad is recommended.
17. Do not leave unit unattended during use.
18. Always use the product on a clean, flat, hard, dry and heat
resistant surface. There should be no material such as a
tablecloth or plastic between the unit and surface. A fire may
occur if the waffle maker is covered or touching flammable
material, including curtains, draperies, walls, and the like, when in
operation.
19. It is absolutely necessary to keep this appliance clean at all times
as it comes in direct contact with food.
20. Be careful not to scratch the non-stick coating of the cooking
plate, as you might get little pieces of this coating into the food. If
scraping is necessary, unplug the appliance and use a wooden
spatula or a heat resistant plastic one.
21. DO NOT touch the cover during use. HOT SURFACE!
22. Never impact this unit or drop from a high place.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
POLARIZED PLUG INSTRUCTIONS
This appliance is equipped with a polarized plug (one blade is wider
than the other). To reduce the risk of electric shock, this plug will fit
into the polarized outlet only one way. If the plug does not properly
fit into the outlet at first, reverse it. If it still does not fit, contact a
competent qualified electrician. Do not attempt to modify the plug in
any way.

SHORT CORD INSTRUCTIONS

A short power supply cord is provided to reduce the hazards resulting
from becoming entangled in, or tripping over a longer cord.
Extension cords may be used if care is exercised in their use.
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
3
Assembly page 3/28
special instruction from Team
Print only
WM 42281 - 120501