MSI 790GX-G65 Serie Manuel D'utilisation page 18

Installing Memory Modules
1. The memory module has only one notch on the center and will only fit in the right
orientation.
2. Insert the memory module vertically into the DIMM slot. Then push it in until the
golden finger on the memory module is deeply inserted in the DIMM slot. The plastic
clip at each side of the DIMM slot will automatically close when the memory module
is properly seated.
Important
You can barely see the golden finger if the memory module is properly inserted
in the DIMM slot.
3. Manually check if the memory module has been locked in place by the DIMM slot
clips at the sides.
Important
- DDR3 memory modules are not interchangeable with DDR2 and the DDR3
standard is not backwards compatible. You should always install DDR3
memory modules in the DDR3 DIMM slots.
- In dual-channel mode, make sure that you install memory modules of the
same type and density in different channel DDR DIMMs.
- To enable successful system boot-up, always insert the memory modules
into the DIM M1 first.
Notch
Volt
En-9