Weld Output Terminals; Connecting To Weld Output Terminals - Milller Wildcat 200 Manuel D'utilisation

5-6. Weld Output Terminals

5-7. Connecting To Weld Output Terminals

6
3
4
5
Tools Needed:
3/4 in.
1 2
1
.
A complete Parts List is available at www.MillerWelds.com
!
Stop engine.
1 Negative (−) Weld Output
Terminal
2 Positive (+) Weld Output
Terminal
For Direct Current Electrode Positive
(DCEP), connect work cable to Neg-
ative (−) terminal and electrode hold-
er to Positive (+) terminal.
For Direct Current Electrode Negat-
ive (DCEN), connect work cable to
Positive (+) terminal and electrode
holder to Negative (−) terminal.
!
Stop engine.
!
Failure to properly connect
2
weld cables may cause exces-
sive heat and start a fire, or
damage your machine.
.
Do not place anything between
weld cable terminal and copper
bar. Make sure that the surfaces
of the weld cable terminal and
copper bar are clean.
1 Correct Weld Cable Connection
2 Incorrect Weld Cable
Connection
3 Weld Output Terminal
4 Supplied Weld Output Terminal
Nut
5 Weld Cable Terminal
6 Copper Bar
Remove supplied nut from weld out-
put terminal. Slide weld cable termi-
nal onto weld output terminal and se-
cure with nut so that weld cable termi-
nal is tight against copper bar.
805 254 / 237 335
803 778-B
OM-237 711 Page 25