Engine Prestart Checks - Milller Wildcat 200 Manuel D'utilisation

5-4. Engine Prestart Checks

Full
Check all fluids daily. Engine must be cold
and on a level surface. Unit is shipped with
10W30 engine oil.
.
Follow run-in procedure in engine
manual.
NOTICE − This unit has a low oil level
switch that stops the engine if oil level is low
or engine is operated at an angle exceed-
ing 105. However, some conditions may
cause engine damage before the engine
shuts down. Check oil level often.
Open side service door.
.
Full
Gasoline
Fuel
Add fresh fuel before starting engine the
first time (see maintenance label for speci-
fications). Always leave filler neck empty to
allow room for expansion. Check fuel level
on a cold engine before use each day.
Oil
After fueling, check oil with unit on level
surface. If oil is not up to full mark on dip-
stick, add oil (see maintenance label).
.
Do not exceed the "Full" mark on the
oil level dipstick. The fuel pump may
A complete Parts List is available at www.MillerWelds.com
operate erratically if crankcase is over-
filled.
.
Change oil after first 20 hours of opera-
tion and then every 100 hours.
.
To improve cold weather starting:
Keep battery in good condition. Store
battery in warm area.
Use correct grade oil for cold weather.
Close side service door.
803 754-D / 217 015-A
OM-237 711 Page 23