DFC-10P / DFC-50P / DFC-450P / DFC-650P
Quick Start Guide
First connect the red charging lead to the positive on the battery.
Connect the black charging lead to the negative on the battery.
Select your required output voltage, mode and setup options on the battery charger:
a) For DFC-650P models, turn the operation dial to either jump start or charge modes, the higher the
number, the higher the amperage. The timer dial must be used with numbers 4, 5 and 6 on the
operation dial.
b) For DFC-650P models insert 3 x 50a fuses into the fuse holder. For DFC-450P models use 2 x 50a
fuses.
c) Select your required output voltage or jump start mode (applies to specific models).
Connect the charger to a power outlet and turn it on.
The charger will begin charging, if your battery is / becomes full charged, the charger will automatically
switch to trickle charge / stop charge.
For jump start operation, only apply a jump start for a maximum of 5 seconds and then allow a 20
second cool down time.
After use, switch off the battery charger and disconnect from the power outlet.
Disconnect the black charging lead from the negative terminal of the battery.
Disconnect the Red charging lead from the positive terminal of the battery.
Screw or press the battery plugs back into position.
Safety Features
This battery charger features a range of safety features. In the event of a blown fuse, the fuse must
be replaced with an identical fuse. The automatic circuit breaker will stop charging in the event of
overheating. This will automatically start charging again after cooling.
The battery must be disconnected from the vehicle prior to connecting the battery to the charger. Failure
to do so may extensively damage the vehicle and or chargers electric systems.
© ROHR
English
3