Televes 7265 Manuel D'instructions page 30

User´s Manual
MAINTENANCE
1.- Do not expose your URC to dust, strong sunlight, humidity, high temperature,
or mechanical shock.
2.- Do not use old and new batteries together as old batteries tend to leak.
3.- Do not use corrosive or abrasive cleansers on your URC.
4.- Keep the unit dust free by wiping it with a soft, dry cloth.
5.- Do not disassemble your URC, it contains no user-serviceable parts.
TROUBLESHOOTING
Q.- My URC does not work at all!
A.- Check your A/V device, if the device's main switch is turned off, your URC
could not operate your device.
A.- Check whether your batteries are inserted properly and are in correct +/-
marks.
A.- lf the batteries are low, replace the batteries, See "HOW TO INSTALL
BATTERIES".
Q.- lf several Device Codes listed under the brand of my A/V device, how
can I select the correct Device Code?
A.- To seek the correct Device Code for your A/V device, test the Codes one by
one until most keys work properly.
Q.- My A/V equipment responds only to some of the cornrnands.
A.- You have set a code for which only some commands work properly but some
do not. Try other codes until most keys work properly.
Q.- My URC indicator shows error in learning commands from other A/V
remote control.
A.- Make sure you are aiming your A/V remote control to the URC on a flat surfa-
ce, 5 - 8 cm apart.
A.- Make sure the learning procedures are carried out in an environment free
from direct sunlight and/or strong light.
A.- Clean the IR transmission lens from your A/V remote and try again.
A.- Check the batteries inside the A/V remote control. lf the batteries inside the
A/V remote control are weak, the URC cannot learn proper command.
A.- Make sure the distance between the A/V remote and your URC remains the
same throughout the whole learning procedures.
Q.- Some learning commands in my URC do not work.
A.- Those signals are not learned properly. Try to teach your URC again for those
functions.
A.- Check the batteries inside both A/V remote and your URC. If the batteries are
weak, the URC cannot learn proper command. You have to replace all batte-
ries for proper functioning.
Universal Remote Control
30