Table des Matières
Publicité
G
GENERAL INFORMATION
- This product meets the requirements of Pollution Degree 4
and therefore can be used in exposed weather conditions.
- This product is not suitable for supplying drinking water.
- Threaded water connections are suitable for hand tightening
only.
- This product should only be fitted to a mains water supply.
- Please follow the instructions to make sure that you get the most
from your timer for simple and efficient watering.
INSTALLING THE BATTERIES
You must use Alkaline batteries - alternatives will result in
incorrect operation.
1. Remove screws and back cover.
2. Insert two 1.5V 'C' Alkaline batteries. (Check + and - are
correct.). IMPORTANT: Rechargeable batteries must not be used.
3. Replace batteries each season. (max 12 months use)
MAINTAINING THE WATERPROOF SEAL
1. Ensure that rubber seal is positioned correctly.
2. Replace back cover and screw down tightly.
3. Repeat each time back cover is removed.
HOW TO PROGRAMME THE TIMER
There are two watering operations - Automatic and Manual.
AUTOMATIC OPERATION
1. Set the current time
Turn dial to the nearest hour on the Red scale (24 hour clock)
then press the
button. An audible beep confirms correct
setting.
2. Set the watering start time
Turn dial to the nearest hour to your desired start time on the
Red scale (24 hour clock) then press the S button. An audible
beep confirms correct setting.
3. Set the watering frequency
This can be set in hours (every 6, 8, 12, or 24 hours) or it can be
set in days (every 2, 3 or 7 days). Turn dial to desired setting on
the Green scale and then press the Green button. An audible
beep confirms correct setting.
4. Set the watering duration
Turn dial to number of watering minutes required on the Blue
scale and then press the Blue button. An audible beep confirms
1
correct setting.
5. Turn dial to AUTO to start the selected programme.
Automatic OFF
Turn dial to ON or OFF.
If you wish to return to Automatic watering re-select AUTO.
Changing current time, start time, watering frequency or
duration
Turn dial to desired setting and press the relevant button as
instructed above.
NOTE: You do not need to reset all settings.
MANUAL OPERATION
Manual ON
Turn dial anti-clockwise to ON.
Water will flow for 60 minutes maximum or until turned to OFF
setting.
Note: After 60 minutes water shuts off. Knob will still point to ON
and needs to be manually set to OFF or to desired number of
automatic watering minutes.
Manual OFF
Turn dial clockwise to OFF.
Note: Operation is only audible when valve opens and closes. To
check that timer is working, switch to manual ON or OFF to hear
valve operate.
CONNECTING THE TIMER TO THE TAP
Use supplied adaptors if required. Tighten to ensure no leaks.
PROBLEM SOLVING
PROBLEM
Valve opens and closes when
batteries are first inserted but then
fails to operate when dial is at ON
or OFF.
Valve works but no water flows.
Valve works on manual but no
automatic watering.
Knob points to ON but no
watering.
PROTECT YOUR WATER TIMER FROM FROST. REMOVE
FROM THE TAP IN WINTER. PRODUCT NOT
GUARANTEED AGAINST FROST DAMAGE. REMOVE
BATTERIES WHEN NOT IN USE.
SOLUTION
Your AC+ has detected poor
batteries. Replace with new
ALKALINE batteries.
Check tap is turned on.
Set Auto Start time
Manual ON 60 minutes is finished.
Switch off or turn to desired
automatic watering time.
2
Publicité
Table des Matières
