Declaration Of Conformity - Beta 1949DGT/2 Notice D'utilisation Et Instructions

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

OPERATION MANUAL AND INSTRUCTIONS

• Tyre pressure adjustment

• - To deflate, gently press the lever to approximately half stroke. Release the liver to display tyre pressure.

• - To inflate, press the lever to stroke end. Release the liver to display tyre pressure.

Display light

After turning on the tool, press the on/unit/light key again, to enable the screen light.

If the tool is not used for 5 seconds, the light will be disabled.

Measurement unit selection

To select the unit of measurement, push and hold the on/unit/light key longer than 3 seconds; then press the key to select the

required unit of measurement from those displayed - PSI, BAR, KPA, KGF.

Auto power off

If the tool is not used for 90 seconds, it will turn off automatically. To turn it on, press the on/unit/light key.

When the tool is turned on, it will be set to the latest unit of measurement.

MAINTENANCE

Repair and calibration must be carried out by trained personnel only. For this operations, you can contact Beta Utensili S.P.A.'s

repair centre.

DISPOSAL

The crossed-out wheelie bin symbol on the equipment or packaging means that the product should be collected separately from

other types of urban waste at the end of its useful life.

Any user who is going to dispose of this tool can:

- deliver it to an appropriate collection facility for electronic or electrotechnical equipment;

- return it to the dealer upon purchase of a new, equivalent item of equipment;

- in case of a product for professional use only, contact the manufacturer which will arrange for the product to be properly

disposed of.

Proper disposal of this product allows the raw materials contained in it to be reused and prevents damage to the environment or

human health. Illegal disposal of this product is a violation of the provision concerning the disposal of hazardous waste and will

give way to the application of such fines as provided for under current regulations

WARRANTY

This tool is manufactured and tested in accordance with current EU regulations, and is covered by a 12-month warranty

for professional use or a 24-month warranty for nonprofessional use. We will repair any breakdowns caused by material or

manufacturing defects by fixing the defective pieces or replacing them at our discretion. Should assistance be required once or

several times during the warranty period, the expiry date of this warranty will remain unchanged. This warranty will not cover

defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition, this warranty will no longer be valid if any

changes are made, or if the pneumatic tool is forced or sent to the customer service in pieces. This warranty explicitly excludes

any damage to people and/or things, whether direct or consequential.

