Beta 1949DGT/2 Notice D'utilisation Et Instructions page 5

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
OPERATION MANUAL AND INSTRUCTIONS FOR TYRE INFLATOR MANUFACTURED BY:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845, Sovico (MB)
ITALY
Original documentation drawn up in ITALIAN.
CAUTION
IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING
THE PNEUMATIC TOOL. FAILURE TO COMPLY WITH THE SAFETY
STANDARDS AND OPERATING INSTRUCTIONS MAY RESULT
IN SERIOUS INJURY.
Store the safety instructions with care and hand them over to the users.
PURPOSE OF USE
- The tyre inflator can be used for the following purposes:
• inflating and checking tyre pressure in cars, motorcycles, lorries, earth moving vehicles;
• use with air or nitrogen.
- The tyre inflator must not be used for the following operations:
• use to inflate or check the pressure of tyres containing anti-puncture liquids;
• locking the operation buttons with adhesive tape or clamps;
• use for any applications other than recommended ones.
WORK AREA SAFETY
Keep children and bystanders away from your workplace while operating the tyre inflator. Distractions from other people
can cause you to lose control over the tool.
Beware of the danger of tripping over the air hose.
PNEUMATIC TOOL SAFETY
- Check the connections and the air supply lines. All units, couplers and hoses should conform to the product specifications in
terms of pressure and air volume. Too high pressure can cause damage and/or injury.
- Do not bend or tighten any hoses. Avoid using solvents and sharp edges. Keep the hoses away from heat, oil and rotating
parts. Immediately replace any damaged hose. A defective feed pipe may cause uncontrolled movements of the compressed
air pipe. Raised rust or chips may cause eye injury. Make sure that the hose clamps are always secured firmly.
PERSONNEL SAFETY
- Stay alert; watch what you are doing.
- Do not point the air flow to yourself or other people. Compressed air can cause serious injury.
- The exhaust air of the pneumatic tool can contain water, oil, metal particles and impurities, which may cause hazards.
PNEUMATIC TOOL USE AND CARE
- Check that the tyre inflator is in good condition: make sure that no parts have been damaged.
- Always check that the tyre inflator is intact.
- Do not use the product if the operation buttons/levers are defective. A tool that can no longer be stopped or started is
dangerous and must be repaired.
- Always disconnect the air supply before making adjustments on the tyre inflator.
- Do not modify the tyre inflator. This can reduce the effectiveness of safety measures and increase operator risk.
- Have the tyre inflator repaired through trained staff and only using original replacement parts.
EN I
5