Connecting The Sensor Or Sensors To The Measuring Instrument And Starting Up - Parker SCPT-CAN Mode D'emploi

. Connecting the sensor or sensors to the measuring instru-
ment and starting up
Using a connection cable, the individual sensor or sensor bus system
should be connected to one of the CAN ports on the Parker Service Mas-
ter Plus measuring instrument.
After the measuring instrument is turned on, the sensor is automatically
detected and initialized. The start screen appears on the display after this
process has ended. The LED signals on the CAN sensors are used for
identification and status display.
► Additional information about the LED signals can be found in the
"LED signals on the sensor" table.
After the boot-up process, you can make further setting changes on
the Parker Service Master Plus measuring instrument or you can begin
measuring.
► Additional information about operating the Parker Service Master
Plus measuring instrument can be found in the instrument's operat-
ing instructions.