Warn 80368 Instructions D'installation page 4

VI. INSTALLATION
1. Remove front grill plate from vehicle, as
shown in Figures 1 and 2. A #27 Torx screw-
driver can be used to loosen hardware. Fig-
ure 2 shows grill plate removed and holes that
will be used later to mount the winch plate.
2. Remove three capscrews holding bottom of
bumper in place using a 9/16" socket, as
shown in Figure 3. Keep hardware to rein-
stall later.
3. Remove three #25 torx screws on each side of
bumper as shown in Figure 4. Keep hardware
to reinstall later.
Grill Plate Mounting Hardware
Holes to mount winch plate
PAGE 4
Figure 1
Figure 2
Figure 3
80369A0