Commissioning; Operation; Maintenance And Repair; Decommissioning - Bosch Rexroth LTS350D Mode D'emploi

3 608 870 0D6/2011-12 | LTS350D/LTE350D
7

Commissioning

CAUTION
Risk of damage to persons and
property!
Commissioning of the LTS350D/LTE350D
servo amplifiers requires basic mechanical
and electrical knowledge.

Only qualified personnel (see "Person-
nel qualifications" on page 19) are au-
thorized to commission the system.

Once the device has been switched off,
it cannot be switched back on again un-
til at least 30 seconds have elapsed.
If you use the components in an existing sys-
tem as a replacement or an extension, you
must install the firmware that is used in the
system.
Before commissioning, check that all plug-in
connections are firmly fitted.
CAUTION
Risk of damage to persons and
property!
Electric shock during operation of the
LTS350D/LTE350D servo amplifiers
without tightening spindle! Voltage is
applied to the XDS2 or XDS1 interface.

Remove the LTS350D/LTE350D
servo amplifiers to which no tightening
spindle is connected from the BT356
card rack field or the SB35x system
box.

Close the unoccupied slots with a
dummy panel.
Bosch Rexroth AG
8

Operation

Operation is not necessary while the system is
running.
9 Maintenance and re-
pair
Cleaning and care
CAUTION
Any dirt or liquids penetrating the
device lead to malfunctions!
Safe function of the LTS350D/LTE350D
servo amplifiers is no longer ensured.

Always ensure absolute cleanliness
when working on the LTS350D/
LTE350D servo amplifiers.
Maintenance
The LTS350D/LTE350D servo amplifiers are
maintenance-free if used as intended.
Spare parts
Please refer to the address directory under
www.boschrexroth.com and in chapter
"16 Service and sales" on page 30 for the
addresses of our foreign subsidiaries.
10

Decommissioning

For details about how to disassemble or
replace your LTS350D/LTE350D servo
amplifiers please refer to chapter "11
Disassembly and replacement" on page 28.
27/88