Twin-Star International ClassicFlame 52EB497GRA Manuel D'instruction page 9

SECTION 5: WIRNG CONTROL BOX
1.) Mount one standard single gang junction box in the wall.
2.) Prepare 2 orange 18AWG wires, pull one end through the hole on the cover of junction box.
3.) Connect one of orange wires to K1 from the unit.
4.) Connect another orange wires to K2 from the unit.
5.) Find the signal wire which was provided with product. Pull the end through the hole on
the cover of junction box.
6.) Plug the wire marked S into the unit.
7.) Insert all wiring black into the junction box on the unit and secure with a wire tie.
8.) Pull the other ends of 2 orange 18AWG wires and signal wire through the hole on wall
outlet.
9.) Connect one of the orange wires to C1 from the control box.
10.) Connect another orange wire to C2 from the control box.
11.) Plug the signal wire into the control box.
12.) Secure the control box to wall outlet.
13.) Ensure that all connections are tight. ( see figure 11)
Orange
Orange
Black
18AWG WIRE
(NOT SUPPLIED)
Orange
Orange
Black
EXTENSION SIGNAL CABLE (SUPPLIED)
Figure 11
Orange
Orange
Orange
Orange
Black
Black
SIGNAL CABLE
E-8