Before Use; Garment Steamer Assembly; Pole Assembly; Locking The Pole - STEAMONE H3S Manuel Utilisateur

Before Use

Garment steamer assembly

Pole assembly:

1. Place the base on the floor and remove the
fig.3
2. Unscrew the fastening lock from the base of
3.
fig.5
1. Adjust the pole to its maximum height by sliding it upwards
fig.6
2. Insert vertically the hanger into the hook until it is firmly
3. Place the head support/hook on the top of the pole and push
fig.7
fig.8
water tank. (fig.3)
the steamer. (fig.4)
Insert the pole and tighten the pole's fastening
lock by turning in a clockwise direction until
the fastener is securely in place. (fig.5)

Locking the pole:

then tightening up the three screws. (fig.6)
fixed. (fig.7)
down to secure. (fig.7)
Hose & Steam head assembly:
resistance is felt. Lock the connector by turning
clockwise. (fig.8 & fig.9)
support/hook. (fig.1)
fig.9
1. Push the hose connector into the base until
2. Hang the steam head on the head
fig.6
fig.4
7