Usage And Maintenance Instructions - Panadero NIMES Instructions D'utilisation Et D'entretien

USAGE AND MAINTENANCE INSTRUCTIONS

You have purchased a PANADERO product. Apart from correct maintenance, our
woodstoves require installation strictly in accordance with legislation. Our products conform
to the EN 13240:2001 and A2:2004 European norm, however it is very important for you
the consumer to know how to correctly use your woodstove following the recommendations
we set out. For this reason, before installing our product you must read this manual
carefully and follow the usage and maintenance instructions.
ASSEMBLY INSTRUCTIONS
1) Lift lid of oven in upper part of stove.
2) Place the cast iron grill inside the stove.
3) Place glass door on the hinges.
4) Screw handle onto upper lid of stove.
5) Place fire-break plate on inclined angles.
POSITION OF THE SMOKE PIPE
1) Place right-angled tube joint in smoke outlet at back of stove.
2) Place tube in bend, and do the same with the other tubes.
3) Join it to the rest of the chimney.
INSTALLATION
- All local regulations, including those referring to National and European standards need
to be complied with when installing the appliance.
- The installation of the smoke outlet must be as vertical as possible, avoiding the use of
joints, angles and deviations. If the installation is connected to a masonry chimney pipe
we recommend the tubes reach the exterior exit. If the smoke outlet is via tubing only, at
least three meters of vertical tubing are recommended.
- IMPORTANT: The installation and regular cleaning of this stove must be carried out by
a qualified professional. The ventilation opening must never be obstructed.
- IMPORTANT: The woodstove must be installed in a well ventilated place. It is advisable
to have at least one window in the same room as the stove which can be opened.
- The tube connections should be sealed with a refractory putty to prevent soot from falling
through the joints.
- Do not position the stove near combustible walls. The stove should be installed on a non-
combustible floor surface, if not a metal plate covering the bottom surface area of the
stove must be placed underneath it and extend further than 15 cm at the sides and 30
cm at the front.
- Whilst the stove is in use remove any material nearby which could be damaged by the
heat: furniture, curtains, paper, clothes, etc. The minimum safety distance from adjacent
combustible materials is as shown on the last page of this manual.
4