Troubleshooting; Disposal - Lux Tools K-FSP-3 Manuel D'utilisation

Airbrushpistole_101107.book Seite 21 Mittwoch, 6. April 2016 2:40 14
– Thoroughly wash the paint mixing glass
with water or suitable solvent (in accord-
ance with the type of paint used).
– Fill the paint mixing glass with a little
water or suitable solvent, connect the
spray stylus again and spray until empty.
– Repeat this process until all traces of
paint are gone.
Note: The compressed air nozzle (3)
and paint nozzle (4) may also be
unscrewed for cleaning.
Error/Fault
Device does not work.
No pressure or low pressure is
generated.
Interrupted paint spray or in-
termittent paint output.
Spray pattern not complete.
Spray pattern irregular with
drips.
If you can't fix the fault yourself, contact your
nearest vendor. Please be aware that any
improper repairs will also invalidate the war-
ranty and additional costs may be incurred.

Troubleshooting

What to do when something doesn't
work...
Malfunctions are often caused by minor
faults. You can easily remedy most of these
yourself. Please consult the following table
before contacting the vendor. You will save
yourself a lot of trouble and possibly money
too.
Cause
No pressure?
Contamination in the system? Check the connections, check
Leakages?
Paint almost run out?
Too high a viscosity?
Paint nozzle loose?
Holding the spray stylus incor-
rectly?
Compressed air nozzle con-
taminated?
Paint nozzle contaminated?
Unsuitable paint?
Paint nozzle defective?
Too high a viscosity?
Too little working pressure?
Compressed air hose defec-
tive?

Disposal

Disposal of the appliance
This appliance must not be disposed of with
regular household waste! Dispose of the
appliance in the appropriate manner. For
more information, consult your community
waste disposal service.
DANGER! Risk of injury! Unprofes-
sional repairs may mean that your
device will no longer operate safely.
This endangers you and your envi-
ronment.
Remedy
Check the pressure system,
connection and hoses.
the pressure system.
Inspect all connections and
hoses for leak-tightness or
blockage.
Refill with paint.
Thin the paint.
Tighten the paint nozzle.
Correct the holding angle.
Clean the compressed air noz-
zle.
Clean the paint nozzle.
Use a suitable paint mixed to
the correct ratio.
Contact your local vendor.
Thin the paint.
Increase the working pressure.
Contact your local vendor.
GB
21