Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
VI. INSTALLATION
1.
If necessary, remove winch and winch plate.
Remove winch hook so winch can be removed
without the need to remove roller fairlead from
the mounting plate. It will be nessecary to
remove the front skid plate.
2. Remove the lower stock M8 fasteners that
connect the front grab bar to the lower frame
connection points
3. Slide plow mounting plate into place from the
side opening of ATV (Figure 2). The plow
mounting plate should sit in front of the frame
rails. The two lower mounting tabs of the plow
mounting plate will align with the M8 fasteners
removed in step 2.
4. Using the provided M8-1.25 x 20mm bolts (B3),
replace the bolts removed from the lower grab
bar mounting location in step 2. Insert into the
lower mounting tabs on the plow mounting plate
into the grab bar and the frame mounting position
Do not tighten completely.
WARN INDUSTRIES
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
PAGE 4
Figure 1
Figure 2
Figure 3
79404A1
Publicité
Table des Matières
