Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
VI. MAINTENANCE/CARE
•
Inspect all metal parts on the plow, plow mount, and related hardware. Replace all parts that appears
rusted or deformed prior to use.
Inspect all nuts and bolts on the plow, plow mount, and related hardware prior to each use. Tighten
•
all nuts and bolts that appear to be loose. Stripped, fractured, or bent bolts or nuts need to be
replaced immediately.
Check all cables prior to use. Replace cables that are worn or frayed.
•
Check all moving and rotating parts. Remove debris that may inhibit the part from moving freely.
•
VII. TROUBLE SHOOTING
Trouble
Inspection
Difficulty
A. Check that the
getting bolts to
side slots in
line up with
skidpan align
holes in
with the hole
chassis.
and nut in the
chassis.
Difficulty
A. Check the
getting plow
alignment of the
pins through
plow mount
the plow and
holes in relation
plow mount.
to the plow
holes.
The electric
A. Check the
actuator cable
termination of
will not rotate
the actuator
within the
cable.
termination
bracket.
WARN INDUSTRIES
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
Diagnosis
1. Make sure the
skidpan slots
aligns with the hole
when the mount is
not compressed
against it.
2. Make sure the
skidpan slots align
with the hole when
the U-bolts are put
through the
skidpan.
1. Make sure the plow
and vehicle are
both on a flat non-
sloping surface.
2. Make sure the plow
holes align per-
fectly with the plow
mount holes.
1. Make sure the
cable is in the slot
of the termination
bracket, the
cylindrical pin is
attached to the
cable, and the
termination bracket
is attached such
that it leans toward
the plow blade.
PAGE 7
Action
1. Adjust and move the
skidpan while compressing
the plow mount against it
until the skidpan slots align
with the hole.
2. Increase the diameter or slot
the holes drilled through the
skidpan until the skidpan
slots align with the holes.
1. Move the plow and vehicle
to a flat non-sloping surface.
2. Place a smaller diameter rod
(such as a drill bit) through
the holes and align the two.
Once the two are aligned,
hold the plow in place and
put the plow pin through the
two holes.
1. Mount the bracket to the
plow crossmember on the
plow blade side angling
toward the blade. Slide the
end of the actuator cable
through the termination
bracket slot. Slide the
cylindrical pin over the end
of the cable and terminate
with a 1/4" nut (D). The
completed assembly should
look like Figure 12.
79404A1
Publicité
Table des Matières
