Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION CONT.
5. Place the 2 M8-1.25 U-bolts (B1) into position
around the frame rails and into the plow mount-
ing plate. Attach using 2 flat washers (B2) and
2 M8-1.25 locking hex nuts (B4) see figure 3.
6. If a winch is not being used in conjunction with
this plow mounting kit then the support bracket
(A2) will need to be placed into position at this
time. Move to step 8 if using a winch.
7. Attach the support bracket to the plow mounting
plate using 2 M8-1.25 x 20mm hex bolts (B3),
flat washers (B2) and M8-1.25 locking hex nuts
(B4), do not tighten at this time. Attach the rear
panel of the support bracket to the frame rails
using the M10-1.25 x 16mm hex flange bolts
(B5).
8. If the winch is being utilized with the plow
mounting kit the support bracket will not be
needed. Place the winch and mounting plate into
position and attach to the plow mounting plate
using 2 M8-1.25 x 25mm hex bolts and lock
washers that attach the rear feet of the winch.
These fasteners will be found in the winch
hardware kit. Run the bolts up through the plow
mounting plate and the winch mounting plate and
into the winch. Attach the rear panel of the
mounting plate to the frame rails using the M10-
1.25 x 16mm hex flange bolts (B5).
NOTE: Please see the WARN winch installation
instructions to install the roller fairlead.
WARN INDUSTRIES
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
PAGE 5
Figure 4
Figure 5
Figure 6
79404A1
Publicité
Table des Matières
