Troubleshooting - JVC Everio GZ-HM690U Guide De L'utilisateur

When the battery life is reached, the recording time becomes shorter even if the battery
0
pack is fully charged. (Replace the battery pack with a new one.)

Troubleshooting

If you encounter problems with this unit, check the following before requesting service.
1 Refer to "Trouble" below.
2 Refer to the "Troubleshooting" section in the "Detailed User Guide".
If you have difficulties operating the unit, refer to the detailed descriptions in the "Detailed
User Guide".
http://manual.jvc.co.jp/index.html/
0
3 Refer to the FAQ of new products on JVC's website.
http://www.jvc.com/
0
4 This unit is a microcomputer-controlled device. Electrostatic discharge, external
noise and interference (from a TV, a radio, etc.) might prevent it from functioning
properly.
In such a case, reset the unit.
A Turn off the power. (Close the LCD monitor.)
B Remove the AC adapter and battery pack from this unit, reattach them, open
the LCD monitor and this unit powers on automatically.
5 If the above do not solve the problem, consult your nearest JVC dealer or JVC
service center.
Trouble
Trouble
POWER/CHARGE
lamp starts blinking
when the monitor is
closed.
Recording cannot be
performed.
Recording stops
automatically.
Sound or video is
interrupted.
For more information, refer to the Detailed User Guide
26
http://manual.jvc.co.jp/index.html/
Action
The battery pack is being charged.
0
Check the A / B button.
0
Set to the recording mode by tapping the
0
R button on the screen.
Turn off this unit, wait for a while, and turn
0
it on again. (This unit stops automatically
to protect the circuit when the
temperature rises.)
Recording stops automatically after 12
0
hours of continuous recording.
Sometimes playback is interrupted at the
0
connecting section between two scenes.
This is not a malfunction.
Page
8
14
16
-
-
-