Installation Flow Chart; Selecting A Location - Samsung WF457ARG Serie Manuel D'utilisation

Installing your washer
INSTALLING YOUR WASHER
Before STEP 5 is complete, do not plug the power cord into a wall socket.
CAUTION
Packaging materials can be dangerous to children; keep all packaging material (plastic bags,
polystyrene, etc.) well out of the reach of children.
WARNING

Installation flow chart

Selecting a
location
Please
check again
before
steps.
Yes
STEP 1

Selecting a location

Before you install the washer, make sure the location:
• Has a hard, level surface without carpeting or flooring that may obstruct ventilation Is
away from direct sunlight
• Has adequate ventilation
• Is not exposed to freezing temperatures (temperatures are never below 32 °F or 0 °C)
• Is away from heat sources such as oil or gas
• Has enough space so that the washer doesn't stand on its power cord
STEP 2
Removing the shipping bolts
Before installing the washing machine, you must remove all
shipping bolts from the back of the unit.
1. Hold the shipping bolt with your hand and pull it through
the wide section of the hole. Repeat for each shipping bolt.
2. Fill the holes with the supplied bolt hole covers.
3. Store the shipping bolts in a safe location where they can
be easily retrieved in the event that you have to move the
washing machine in the future.
20_ Installing your washer
WF457ARG-03153A-07_EN.indd 20
Removing the shipping
bolts (*Drum only)
Powering your washing
Adjusting the
levelling feet machine
Does
Running a Calibration mode
your washer
have excess vibration
No
or noise?
Connecting the water
and the drain
[Running a test cycle]
Run a test cycle (Rinse+Spin) with
small amount of laundary
(about 4~5 Towels)
(Refer to the following
description)
Finish the
installation
2013-12-13 10:40:18