Aqua Laser CoolAir Manuel D'instructions page 4

STEP 5:
Slide the vertical tubes (J) into the vertical base tubes (H).
NOTE: Once the two vertical tubes are connected, the hanger (1) can be attached.
Attaching the smart hanger (L): The smart hanger can be attached on either side of the upper vertical tubes. (When
attaching the smart hanger, insert the bottom part first and hang the top part, then pull it down to secure.)
Racks easily adjustable to several positions!
Airflow:
Press once: High speed
Press once again: Low speed
Press again: Stop motor
Correct Disposal of this product
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly
to promote the sustainable reuse of material resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was purchased. They can take this product for
environmental safe recycling.
C
HANGER (1): Slide the middle connectors (B) one by one onto the vertical base tube
(H) and tighten lightly
with the fasteners (I).
HANGER (2): Slide the middle connectors (B) one by one onto the vertical tube (J) and
tighten fully with the fasteners (I).