Aqua Laser CoolAir Manuel D'instructions page 3

ASSEMBLY
STEP 1: Fitting the hangers
The hangers (A) are supplied pre-assembled. Push all
hangers (A) individually into the middle connecting
piece (B).
FOR THE TOP HANGER PROCEED IN THE SAME WAY!
To change the angle of the hanger, pull it out of the
device. Select one of the 3 possible angle
positions (top - middle - bottom) and push the hanger
in.
STEP 2: Fitting the base
Push the horizontal base tube (C)
into both feet (D). Put the 6
wheels (E) on the bottom of the
feet (D).
STEP 3: Fitting the motor
Click the 3 parts together to build the
air dampers(G). Insert the air dampers
(G) individually into the motor unit (F).
STEP 4: Fitting the frame
Push the vertical base tubes (H) through the side rods of
the motor unit. Place the assembled motor on the feet (D)
and press down the vertical base tubes (H) to secure.
COMMENT TO FIX THE HANGERS:
Push the middle connecting piece (B) individually onto the
vertical base tube (H). LIGHTLY fix it with the holders (I).
BEFORE TIGHTENING THE
HOLDERS, PERFORM STEP
4.