Coil Elements And Burner Bowls; Home Canning - Amana ACC6356KFW Instructions D'utilisation

Table de cuisson électrique
Masquer les pouces Voir aussi pour ACC6356KFW:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SETTING
RECOMMENDED USE
HI
Medium HI
Medium
Medium LO
LO
REMEMBER: When cooktop is in use, the entire cooktop
area may become hot.
Power On Light
Each control knob will activate the Power On light. The light will
glow red when any control knob is ON.

Coil Elements and Burner Bowls

Coil elements should be level for optimal cooking results. Burner
bowls, when clean, reflect heat back to the cookware. They also
help catch spills.
Cookware should not extend more than ½" (1.3 cm) over the
coil element. If cookware is uneven or too large, it can produce
excess heat, causing the burner bowl to change color. For more
information, see the "General Cleaning" section.
NOTE: Before removing or replacing coil elements and burner
bowls, make sure they are cool and the control knobs are in the
OFF position.
To Remove:
1. Push in the edge of coil element toward the receptacle. Then
lift it enough to clear the burner bowl.
Start food cooking
Bring liquid to a boil
Hold a rapid boil
Quickly brown or sear food
Maintain a slow boil
Fry or sauté foods
Cook soups, sauces, and gravies
High simmer or simmer without lids
Stew or steam food
Simmer
Keep food warm
Melt chocolate or butter
Low simmer using lids
2. Pull the coil element straight away from the receptacle.
3. Lift out the burner bowl.
To Replace:
1. Line up openings in the burner bowl with the coil element
receptacle.
2. Holding the coil element as level as possible, slowly push
the coil element terminal into the receptacle.
3. When the terminal is pushed into the receptacle as far as it
will go, push down the edge of the coil element opposite the
receptacle.

Home Canning

When canning for long periods, alternate the use of surface
cooking areas, elements, or surface burners between batches.
This allows time for the most-recently used areas to cool.
Center the canner on the grate or largest surface cooking area
or element. On electric cooktops, canners should not extend
more than ½" (1.3 cm) beyond the surface cooking area or
element.
Do not place canner on 2 surface cooking areas, elements,
or surface burners at the same time.
The installation of a Canning Unit Kit is recommended. If a kit
is not installed, the life of the coil element will be shortened.
See "Assistance or Service" for instructions on how to order.
For more information, contact your local agricultural
department. Companies that manufacture home canning
products can also offer assistance.
5

Publicité

Table des Matières
loading

Table des Matières